Rheem GEN20AD-E Instrukcja Operatora Pobierz pdf (Strona 26)

Checking/Adding Engine Oil

1. Open roof to access dipstick and oil fill area.

2. Clean the oil fill area of any debris.

3. Remove the dipstick and wipe with a clean cloth.

4. Fully insert dipstick into oil fill.

5. Remove dipstick and check oil level. Verify oil is at Full

mark on dipstick.

6. If needed, slowly pour recommended oil into oil fill

opening. DO NOT overfill. After adding oil, wait one

minute and recheck oil level.

NOTICE Overfilling with oil could cause the engine to not

start, or hard starting.

t DO NOT overfill.

t If over the FULL mark on dipstick, drain oil to reduce oil level to

FULL mark on dipstick.

7. Replace oil dipstick.

8. Close roof and secure.

Changing Engine Oil and Oil Filter

KEEP OUT OF REACH OF CHILDREN. DON’T

POLLUTE. CONSERVE RESOURCES. RETURN USED

OIL TO COLLECTION CENTERS.

NOTICE Any attempt to crank or start the engine before it has

been properly serviced with the recommended oil will result in

equipment failure.

t DO NOT attempt to crank or start the engine before it has

been properly serviced with the recommended oil. This

may result in an engine failure.

t Damage to equipment resulting from failure to follow this

instruction will void engine and generator warranty.

Change the oil while the engine is still warm from running,

as follows:

1. Press and hold the control board OFF button.

2. Remove 15 Amp fuse from control board.

3. Place oil drain hose into an approved container.

4. Remove brass fitting from end of drain hose and drain

oil into an approved container.

5. When oil has drained, replace brass fitting on hose.

6. Place an approved container under oil filter.

7. Remove oil filter and dispose of properly.

8. Before installing a new oil filter, lightly lubricate the oil

filter gasket with fresh, clean oil.

9. Install the oil filter by hand until the gasket contacts

the oil filter adapter, then tighten the oil filter 1/2 to 3/4

turn.

10. Add oil.

11. Remove container from under oil filter and clean up any

spilled oil.

12. Start and run engine. As engine warms up, check for oil

leaks.

13. Stop engine, wait for oil to settle, check oil level and

add if necessary.

CAUTION Avoid prolonged or repeated skin contact with

used motor oil.

t Used motor oil has been shown to cause skin cancer in certain

laboratory animals.

t Thoroughly wash exposed areas with soap and water.

NOT

EPRODUCTION

control bo

ontrol bo

mp fuse from fuse from

ain hose intoain hose into

e brass fittine brass fittin

nto an approvo an appro

When oil hasWhen oil has

6.6.

Place an Place an

7.7.

Remoem

8.8.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 95 96

Komentarze do niniejszej Instrukcji

Brak uwag

Rheem GEN20AD-E Instrukcja Operatora Strona 26

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Generatory prądu Rheem GEN20AD-E